View Single Post
  #80  
Old 08-14-2006, 09:34 AM
nitrorocket's Avatar
nitrorocket nitrorocket is offline
Senior Member
 
Join Date: Jan 2006
Location: Milwaukee Wisconsin
Posts: 488
Thanks: 0
Thanked 0 Times in 0 Posts
Default

I contacted Dennys on my driveshaft, they say it is good to go, especially after shortened for the overdrive. I run a 3.42 gear now and will probably just try that.

I run BFG Comp TA/ZR Tires right now so they are safe.

I will start looking into making some type of a front air dam setup that is possibly removable so I can take it off when not racing, otherwise it would get ripped off every time I go through a drivethrough.

Do the high speed guys use quick ratio steering boxes? I would think this would be bad at high speeds.

Thanks for some of the last few posts, very informative!



And for those of you who think I am a moron, Shut up! How many bikes run roll cages??? You are not dangerous if you don't have a cage and go 150 mph, would it be safer in case of an incident... Yes, of course! I am not any more dangerous going 150 mph in my car then every bike in the world, I would say I am safer in my car as it sits then on a bike. So if every bike rider crazy for going 150 mph with no cage?? All they have is a helmet, jacket, and boots!

Point is My car is very safe for what I have been doing, I dont have a roll cage, but everything else is up to standards, good tires, brakes, sfi approved parts, etc.

AND...Mazspeed...Who said I would be going 200 mph on public streets?? I said I want to start doing some type of road racing! Did you mis understand me?? So far I have not done anything that anyone on this board has not doen on the street, I go through the gears on an on ramp..Is that a big deal?? Have you not?? I drive slower than most people on a regular basis and have a clean record. I am not a wreckless driver by any means, I am putting nobody in danger. Is this understandable??
__________________
Twin Turbo LS1 '71 Chevelle
1000 hp 93 octane street car
6 speed

Last edited by nitrorocket; 08-14-2006 at 09:40 AM.
Reply With Quote