[scherp69]

So looks like I'm going to have to do the wheel bearings in my step daughters car so a press may be in the cards now. I was looking at them today. They have the 20 ton press on sale for 350 and the owner will give it to me even cheaper as he has too many display models. They also have a 45 ton air assisted set up for just over $1000. Most of what I will be using it for is the odd wheel bearing, etc or using dimple dies on the thickest 18 gauge sheet metal. Is it worth the extra money to get the bigger unit? With the the 45 ton, how thick could I go with the dimple dies? Not sure if I would use it very often, but would be nice to be able to do 1/4". Thoughts??