[fakesnake.com]

i went to manual and followed directions below that i copied here-

start vehicle- check
allow compressor to fill tank- check
press preset #3- there were already settings there around 100 or less psi. when i touch preset number 3 it adjusts to that height based on preset pressure readings. When i hold it for awhile it saves whatever pressure i am sitting at.

I didn't get any further then #3 in the calibration process. I didn't have option in picture of press 3 to start set up and or see start up required. It assumed i wanted to either go to preset 3 and or save preset 3. no set up options as further described in the calibration steps for no level sensors.


Calibration Steps: (items in red require user interface, other steps are automatically completed)
These steps will require the car to be running to ensure full battery voltage!
1. Start the vehicle
2. Allow the compressor/compressors to fi ll the tank ( They will shut off @ 150psi )
3. Press preset # 3 to start calibration.
4. Release all air - this provides a solid starting point for the Calibration sequence
5. Locating tank pressure sensor - locates and checks the tank sensor
6. Locating air spring pressure sensors - locates and checks the air spring pressure sensors
7. User must set Preset #2 - allows the user to set the Ride Height ( This can be changed later )
8. Check vehicle speed to and from Preset #2 - the e3 will utilize this information to achieve Ride Height in the fewest possible steps using the
most intelligent method.
9. Determines vehicle speed from lowered height to Preset #2 - the e3 will utilize this information to achieve Ride Height in the fewest
possible steps using the most intelligent method
10. Defl ates down to Preset #1 - tests the system for defl ating to Preset #1
11. Uses Calibration data to travel to Preset #2 - tests the system for infl ating to Preset #2
12. Calibration complete