Quote:
Originally Posted by gerno
All good questions and thanks for confirming
When I first hung the pistons I did not think about the valve reliefs and needed to rehang half of them.... it sucked... There is a left and a right in the kit you you do have to pay attention. I also have all the rods hung correctly with the large chamfer towards the crank.
I set all the ring gaps, took me over a day to do. I decided on the circle track spec which equated to basically .023 2nd and .022 first. I felt I'd rather have a little too much gap and not worry about heat expanding the rings and cracking the piston. It also sucked but the are right on for each hole.
I used ARP lube for all bolts except the rod bolts because Carrillo has a special lube they want to use for there specs
|
And this is why i'm paying someone else to build my engine haha. i would be second guessing myself for months about stuff like this.