since I had an update. MY school work is taking most of my time lately, but I told myself I needed to get out there and get some stuff done before it gets too cold out.
So I cut out the floor for the sub frame connectors, got the drivers side done and most of the pass side. After I cut up the floor supports and found rust I said that's the last sheet metal that I haven't torn apart .... figured, rust had started everywhere else!!
I'll use some Eastwood frame rust inhibitor all through the support and weld her shut.
Question for those before me: the connector DSE gives you to weld the frame and connectors together ... what's peoples doing for a removable frame setup?? Any templates? Any recommendations for strength?
I can't cut 3/16" and make it look good, suggestions?
Drivers side nice and snug, should be easy weld here!
Pass side cut out, yeah RUST !
What to do about that gap prior to welding????
This is the DSE connector .... like to replace it with a bolt thru on the frame.
Need to tear the front swing metal off and get the frame outa the way and get some epoxy on the floor before I get to far and then weld the connectors in for good.
Thanks for looking .... keep on keepin on!