Quote:
Originally Posted by Vince@MSperfab
When you move it with your hand is it the same sound you are hearing?
|
That's hard to say. When I'm inside of the car, things sound a lot different. And at 40-50MPH when I've been listening to this, I expect the rotor to be turning at a higher frequency then it seems like I hear this sound. But there's nothing else I can account for that would make it?
Quote:
Originally Posted by Vince@MSperfab
You can use a rubber/plastic dead blow hammer on the tires and see what it does.
|
Hmm, I can try that.
Quote:
Originally Posted by Vince@MSperfab
The last 2 that we did ran EBC and I had to sand the coating flash on it to fit. It was tight. Your stainless anti rattle clips are in there right?
|
Quote:
Originally Posted by Sieg
Compare the dimensions of the Baer & Hawk backing plates.......while you're checking for the anti-rattle clips.  |
Now these are good questions. I actually don't recall either the Baer's or the Hawk's having them. I will go pull out the Baer's before I take off today and check, but it's been a while since I did this swap.
Strangely, I don't hear anything from the fronts, and I did this at the same thing. Just the rears. I'll take a look and post back.