are ready to weld in! I had the local Metal Dist. cut out some brackets outa 0.125" and got them mocked in tonight, still need to trim the inside cuz the tranny crossmember is right there. I am going into my old work place and borrow their welder to get these attached to the connectors, needed some heat for .125".
Anyway, not very artistic plates .... but practical. Then I'll weld tubes in the frame to stiffen up the bolt holes.
I need to adjust the floor opening to allow the connector to mate to the frame in the same plane .... they are off about a 1/8" to line up, then I can weld em in finally!
Oh, I have that brown truck coming hopefully Wednesday, bringing my .......
Thanks for looking ....