Quote:
Originally Posted by jlwdvm
I'm at the point on my project where I am starting to run the Spertech wire harness to my Texas Speed LS3. I ran the harness through the blower motor hole to get it into the car and under the dash. I will also be mounting the coils under there as well. I am wondering what I will do with the original 2 wiring harnesses that were for the original motor and light harness. I suspect that the light harness will stay, but what about the engine harness? I will be relocating the battery to the trunk as well. Positive wire still terminate at the starter?
|
I usually pull all the unused pins/wires and seal with RTV.
Yep, terminate at the starter. You can run a feed wire off the starter OR use a bulk head on the firewall....near the starter.