Quote:
Originally Posted by rickpaw
Wow, the ground clearance is amazing.
|
Quote:
Originally Posted by waynieZ
They tuck up there nice and tight. Nice work.
|
I'm pretty happy with what I see so far. Of course the car isn't at ride height yet. Still need to add sheet metal and set the alignment but pretty good so far.
Quote:
Originally Posted by GregWeld
Cookin' with gas Steve!
SpeedTech is one of the good companies! Everyone has issues once in awhile... how they deal with it is what matters.
Congrats on the new house and "shed"! LOL
Brizio/Hollenbeck/Mumford and a few others are planning to drive our hot rods to GG Lonestar Nats in April. Then Gwen and I will peel off and hit Austin... so get the friggin' car done so I can have a ride!
|
I recall hearing something very similar to this for Oct yet I never got a phone call....interesting.
If I'm not done by April then I need to reassess my priorities big time
Quote:
Originally Posted by Rick D
Lookin good Steve, can't wait to hear your thoughts on the whole suspension and engine!!
|
Me too. After driving Carbuffs car last week I hope mine measures up.
Today my goal is to setup the clutch, hang the fuel tank, route some fuel lines and maybe route some electrical.
I completed the clutch and don't know how I feel about it. It's fairly stuff and has a very short throw. It's very much like an on/off switch. Perhaps I'm just used to mechanical clutches. The trio is currently 3.5 so I may adjust that or may swap the master. I'll wait until it's driving to figure that out