[WSSix]

Thanks for the replies you guys.

Rick, with all the choices for headers I've seen and am aware of I'm too low for off the shelf designs. As it stands, a typical stacked 4 into 1 collector would hang over an inch below the subframe and that's with the exhaust only 1/2" below the floor. Also, being a WS6 car causes a lot of issues with headers because of two small braces that tie the rearward lower control arm mount to the subframe. I could remove the braces as they are bolt in but they work from what I have read about these cars so I want to keep them. It would be a little easier if I didn't have half height solid bushings.