[rat_rod_russell]

More updates, The exhaust front part is too complex to have 1 piece bent. Some of the bends are too close together and the motors are mounting is different frame to frame so that bit need a little custom attention to make fit exactly. So we got this part mocked up and the braided brake lines finally showed up. I have to order custom lines to have an AN-3 on one end and the 10mm on the other AND have a DOT stamp on the lines. Kore 3 does good work with quality American parts so I don't mind the short wait. These are getting on and worked out as well. The rear half exhaust has been XYZ'd and has been ordered.

Now for the real reason most of you are here, pretty pictures!!!!







Later
-Russell