Quote:
Originally Posted by DOOM
I thought about that Greg but I have to have them working the way they were intended. Its just me.
|
its a pain to get them right but its doable.
if you make the two wholes on the core support bigger it gives you some much needed wiggle room . you'll be surprised how much alignment gets better with just a slight movement. once you get them where you want them. place a washer (with correct ID )to cover enlarged whole, trace perimeter and cut it out, weld washer of correct gauge to match core support and you'll have a nice pretty finish with correct whole location.
also playing with shims ( adding / subtracting ) on door shaft I also used a washer / shim on the core support bolts between core and housing to tilt up or down.
its going to take some pulling and pushing on the rest of it.
hope this helps