Quote:
Originally Posted by KPC67
looking good chief! keep at it.  |
Keeps me outa the bars!
Quote:
Originally Posted by waynieZ
Looking Good! The trans mount came out nice.
|
Scott did a great job fabbing, and then I welded it to the xmember. Its installed finally!
Quote:
Originally Posted by bsharpe
i have been watching this thread closely. I am putting scott mocks subframe and ridetechs 4 link under my 71 trans am clone.
I understand why your are frustrated with the 4 link fitment. I was surprised with issues with the subframe and 4 link. try using the directions to install the 4 link on a ford 9 inch. None of the brackets fit.
Keep up the good work and keep posting your progress. it is appreciated.
|
I read your thread .... everything is fine here, I can't go much lower than 27" and then I don't have any travel left. So .... I'm gonna raise the trunk above the diff and clearance the sway bar mounting bar some.
There's always more to come
Quote:
Originally Posted by SlowProgress
Looks like you are moving along. I need to copy your work ethic ! Beautiful day out in the garage in Phoenix !! |
When time is precious you gotta get going and make a goal to finish something!
Quote:
Originally Posted by coolwelder62
Michael, Your doing a great job. I hope the trans bracket worked to solve the problem of trans crossmember tab being a little short(and the tig welds looked OK) . I based That bracket length off info & 4L60E measurements I got from the auto recycle yard.Sorry for the inconvenience. |
Scott, that bracket was great! I will get you the measurements from bell housing to mounting bolt center one of these days .... I'll put it on my list!
Thanks for looking ....