Quote:
Originally Posted by carbuff
I can't wait to watch this, as I'm interested in Ron's setup as well. I have a question about the housing below, specifically the brakes. That looks a lot like the setup Speedtech (I think it was them) was putting together a couple of years ago which used the C6 bearing as an alternative to a full-floating brake setup. Can you give any more specifics?
|
Quote:
Originally Posted by Vince@MSperfab
Doesn't DSE sell a version too? I remember Tommy had a version right before Steilow released his version. Interesting kit if you want a floater.
|
Quote:
Originally Posted by Ron in SoCal
I know DSE had one in development. Not sure if they worked with Mark on that but wouldn't be surprised. Looking at Mark's, I really like the improvements he made in the axle end placement.
The one above is derived from Tom's original design, I think. I had heard a couple of different versions of that story. He did not manufacture the housing ends as far as I know.
|
Quote:
Originally Posted by Musclerodz
DSE is in development of one, but they are currently only selling the Baer floater as far as I have been told.
|
First off, nice stuff Ron!
Second off, sorry in advance for self promotion below but couldn't resist (would almost give you a set if you want to cut off those proprietary units you have now
)
Thirdly, I think this car may actually need/justify a set of my fabricated steel C6 Uprights
For what its worth in regards to above responses, I am machining a few sets next week of this type rear setup (C6 Flange end), and could easily machine a few more if anyone is interested....
Ok, back to Ron's build!