Quote:
Originally Posted by Z06vette
Probably too late at this point, but today I just dropped the body (69) onto the DSE subframe with motor/trans installed. The brackets on the ATS crossmember are up against the floor. I have the DSE std height mounts. Tim- what trans cross member do you plan to run on Deb's car?
On a second note- I used the 1" setback mounts, and the 102 FAST intake is against the firewall. So I dropped the sub back out for crossmember and engine stand replacement ...
|
The mounts are supposed to be up at the floor. there should be 1/8 - 3/16 gap but that is all.
Just re red the OP first post and the car is a second gen so that is probably the issue the AST Cross member shown a couple post back is a first gen X Member and the second gen has a different shape floor and the side brackets are shorter. I an thinking that is where the confusion is.