[MillerBuilt]

Here are a few shots of the Fixture Pieces. These are the pieces I am loaning out, I will be requiring a deposit that will be fully refundable upon safe return. You will also be responsible for the shipping to/from.

[IMG][/IMG]

[/IMG]

[IMG][/IMG]

I designed the fixture block with a convenient flat spot to allow your Smart Tool or similar in clocking the weld-on C6 Flange so that you can get your Caliper orientation/degree just right!

[IMG][/IMG]

This is another nice little detail to help during installation of your weld-on C6 Flanges. The fixture blocks have been machined in thickness to mimic your wheel mount surface once all your finish components are installed. This way you can pull a tape from outside of fixture block to outside of fixture block and verify your exact WMS to WMS before welding!


[IMG][/IMG]

For you professional shops that may be wanting to make this rear setup a regular part of your builds, I am also selling these same pieces as pictured below... includes inner 3.062 pucks, outer C6 blocks, hardware $425.00 shipped

[IMG][/IMG]