[Greg from Aus]

Originally Posted by Sonar Chief

Good day in the garage .... Figure I'd start on the roll bar now that the connectors are welded in solid, got the drivers side pretty much done. Still need to bend the floor plates to match the rocker panel and put the kicker bars onto the connector, but that's easy.

I gave the roll bar a little angle to match the quarter window and to make it easy to weld the top joints with the roof off ... finally be able to weld on the roof after the quarters are on! I even installed the rear window to make sure it didn't hit, we're good.

Take a look ....













That's all, I'll work on the passenger side tomorrow and get the kickers mocked up and then add some heat ....

Thanks for looking .....

Nice work.