Quote:
Originally Posted by ataves1
Roll bar looks good! nice work
|
Thanks... its time consuming to get it right!
Quote:
Originally Posted by waynieZ
Chief its coming along, looks good, but I don't think that wire is going to pass tech inspection. 
Ahmad good idea. |
I thought it was better than duct tape
Quote:
Originally Posted by Build-It-Break-it
Thanks Wayne. I think the clamps are more affordable and universal then magnets. Plus they don't mess with the arc like a magnet will when tack welding.
|
So I use the same clamps from HF so I made up something similar .... works good thanks for the tip!!
Quote:
Originally Posted by Greg from Aus
Nice work.
|
Thanks ... your car is awesome!
Quote:
Originally Posted by tubbed69
Really starting to come together now,top notch fab work all the way |
Thanks, the fitment is really close and that makes it a whole lot easier to fine tune!
Here is some pixs, still need to fine tune the angle for the main hoop (85 degrees) and bend the plates for the floor.
Made some clamps to hold her in place!
Rear window is in place ... plenty of clearance!
Kickers tuned to fit the connectors!
Better view ... looking cool!
There's tomorrow for the rest (1) fine tune the trunk drops (2) bend all the plates to fit (3) get help to take off the roof so I don't taco the roof (4) start welding!!!!
This is time consuming to get it fit really nice, but it's paying off fer sure!
Thanks for looking ....