Worked on the seat frames a little bit today. I had to grind down the ears on the mounts, so that the rail would sit flat. you can see in the picture that there are existing holes that I can enlarge so that a bolt will fit through.
this is the driver side closest to trans tunnel. I took a hammer to some parts to make it flat.
the front 2 mounting points sit flat as well as one in the back. I had to bend the mount a bit to fit but it turned out great
I will only need to fabricate something for the rear mount closest to the trans tunnel, but some scrap angle iron and a welder will take care of that.
the seat mounts have plastic covers .I was worried someone would hurt their foot here. I prob won't have many rear passengers anyway.
