Not a lot of progress lately. I sent 90% of my machined parts off to be anodized. I can't do a lot until most of that stuff gets back.
I did re-do my water pump feed. I had a rubber hose on it that I found at the auto parts store that was close, but not perfect. I never did like it. So, I made a perfect fitting one from stainless tube and some silicone clamps.
My old header crossover hit the new bellhousing, so I remade it. I used a burns double slip this time instead of a bellows. I like the fit, just hope it seals up.
I've got all the a/c parts except the lines. I'll order the parts to make them as soon as I get all the components mounted.
I found a factory accessory bracket and bought one of the billet tensioners. Other than the fact that it looks like a wiring bomb went off, It's starting to look like a stock GN under the hood again.
