Quote:
Originally Posted by Nativefx
You mentioned this picture was at the "suggested" ride height. Can you tell me what that is or where you got the info? Is it a specific measurement somewhere?
I got my wheels in and I'm trying to get camber set close to -0.5 to -1.0 as suggested so i can see what kind of work I might need to do to inner/outer fenders.
thanks (sorry couldn't figure out how to copy the picture you had attached for reference)
|
I can't remember what it was off hand right now. I got the info from Ridetech. You would think that info would be in the instructions as it is vital to set-up. The measurement is from top of coil over top mount point to bottom of coil over mount point, which is just over the half way point of total travel.
For the front, on my car with 1" drop spindles, it placed the front body line at roughly 24 1/4" to the ground. I built a 1" rake into the car so the back body line is at 25 1//4". But if I were you I would call them as they may have changed things up a little and using my body line measurements would not be very accurate.
David