Quote:
Originally Posted by carbuff
If you are trying to use the stock belt mount locations, those bolts are larger. I think I opened up the hole on the brackets for the floor mounted belts and used the original bolts. I had different ones: some had shoulders, some were just threaded as I recall. I chose the smaller ones to open up the holes the least amount.
Also, I think the brackets are hardened which made opened up the holes a challenge.
If you are creating new mount point in the floor, then I don't see how there could be a problem.
Good luck!
|
This is my problem^^^
I am trying to use the stock lap belt mounts and the bolts are larger diameter.
Guess I could open up the holes on harness brackets and use the original bolts.
The rear shoulder mount is a problem cuz I was planning on running eye bolts in the stock seat belt mount location with the clip on brackets.
Looks like I either need to buy eye bolts of the correct diameter or get 4 reinforcement plates and drill some holes.