Quote:
Originally Posted by 4mul8ion
Uh oh. This sounds like trouble for me.
Not sure if I'm going be be able to resist the urge to upgrade.
Kevin |
This is going to be one very slick piece IMO. I have been working out all the MANY little details and am now ready to go! I wanted to be able to make this a true bolt on that requires NO fabrication, it will benefit EVERYONE that has an existing rear-end that currently has Big Ford "New Style/Torino" ends, and that would like to convert to this C6/7 set-up...
Based on your/others current 2.50" axle offset (most common) on your existing housing, this new C6/7 "bolt-on" set-up will add 1/4" to each sides wheel mounting surface due to design constraints while working around the Big Ford End/C6/7 assembly dimensions....
Many folks will be able to run their existing calipers & rotors too with the addition of new caliper brackets & rotor hats from the manufacturer of the caliper & rotor, so long as they offer your caliper/rotor in a C5/6 application (I know this gets confusing a bit, but I will assist you with all this if you are heading this direction).....
Quote:
Originally Posted by MoparCar
Thanks for the info Jay.
Wes
|
You're welcome Wes!
Quote:
Originally Posted by baddrides
They look sweet Jay, top quality as expected......
|
They gotta be,,,,, got guys like you watching
