Quote:
Originally Posted by cwylie
Whats the max amount of shims I should need to run to get my pinion angle to the required 4 deg? Right now I have right about 5/8's and im only at 1 deg.
|
Are you installing the Torque Arm? If so give me a call because 4 deg is too much.
it is going to depend on your engine angle.
the easiest most basic way to start the set up is equal and opposite angles.
if the engine is at 2 deg down then a good start is 2 deg up on the pinion.
if the engine is WAY down then you will need to raise it. if the drive shaft is running up hill to the pinion then that needs to be addressed First. as it will never be good if that is the case.