Quote:
Originally Posted by CarlC
We do have a RetroWorx kit for single modules. For duals it's usually best to make your own mounting plate.
http://vaporworx.com
Mark, are you using the full fuel system during the dyno runs for validation? |
Carl
That is the plan. We will use the tank in the dyno cell and start with 100% gasoline then go to E85 then look at blends (E50, E25...) To make sure the flex fuel sensor is working correctly.
It is a bit more work to run the system in the cell but then you can control everything.
We will also A/B test the bigger intercooler bricks.
Still a lot of little details to work out.
Mark
On a side note we fired up the hoist last night. No more rolling around on the shop floor.