[cwylie]

Originally Posted by dhutton

Interesting, for some reason I thought there was some machining involved. At least that is what I recall reading somewhere.

Edit: Here are the instructions for the specified pulley. Some machining required:

https://www.lingenfelter.com/sites/l...kit%20v1.1.pdf

Don

If you want to run the really small 2.35 blower pulley you have to grind to tabs off the blower snout which they say to machine off but it would be easily done and look nice with a die grinder, sanding disk and flap wheel. The other thing they recommend is you pin the blower pulley to the input shaft but almost no one does this that I have found and I have not seen any issues.

I used a large 3 jaw puller to get the stock pulley off (bending it in the process) and then pressed the new pulley adapter on with my 20 ton press.