Quote:
Originally Posted by Vince@MSperfab
The sleeves do not fit together. its 1/2 (what you can male) to 1/2 male top and 5/8 to 5/8 bottom. **
You have the right parts....The 1/2" ones go on top and the 5/8" go on the bottom. One 5/8" washer on eash side. So stud, washer, 5/8 spacer, shock, 5/8 spacer, washer then nut. Also real racers position the adjuster at the bottom.  |
Vince .... I'm not a smart man, my picture 2 is what is installed on the top to take the bearing from 5/8 to 1/2 .... duhhhh, check image below!
The lower mount just change up the order? Install washer on the outside of the sandwich? I didn't know that's where they went, I just grabbed two washers.
Adjusters on the INSIDE bottom (Weld's comment) got it!
Now there is interference w the shock and the mount .... what's next? Longer shock stud to push the spring out away from the mount?
Thanks ...
Michael