[Sparky]

Where is the “Brake” wire coming from (where does it originate from)?
If it originates from the Stop Lamp Switch off of the Brake Pedal, then it’s very possible that the “Brake” wire should go to the Column Connector Terminal “P”. This will combine the Turn/Brake Signal through the Left Turn and Right Turn Wires.

Or as Theresa from AAW stated, it might be that the “Brake” wire is the Third Brake Light Wire (CHMSL- Center High Mounted Stop Lamp).

Sorry I’m not familiar with the “EZ-Wire” kit. I usually make my own Harnesses from scratch, primarily because most of my work is Racecar applications.
Any types of “Street Cars” and/or Restorations I get into I usually use AAW.

I hope this helps,
Sparky