The flex hoses are first run thru stainless rubber lined hose clamps that are are secured to the rear end with a large industrial ty-wrap
http://www.cabletiesunlimited.com/ca...x/category/48/ that has an eye on the one end that is secured to the clamp with a stainless steel #8 screw and locknut. The flex hose terminates to the hard line thru the standoff that came with the brake hoses that were purchased thru Tobin @ KORE3. The hardlines terminate at the cross above the rear end attached to an aluminum bracket that I made. I came up with the layout and design so I'll see over time how it works....
Part of the reason for the design was that I had gotten the rear end powder coated and I had forgotten to mock up the brake lines first...
