I really want to get the subframe setup and DSE subframe connectors welded in so I can start to do the final assembly. I used a laser level to level out the car on jackstands and started to get some measurements. I have been reading Ron Sutton's suspension threads but I don't want to get carried away. I just want to make sure everything is straight and centered.
I used a plumb bob and marked every reference point I could find on the floor (outside flares, pinch weld, alignment holes, etc) I then measured from these points to mark the center point. I put a chalk line down the center. I should be able to use this to center and square up the front and rear suspension.
