[BanditDave]

Drivers side was just as easy...just had to bring it up from underneath. Only caution is that near the brake proportioning valve one tube is about .75" to 1" away from a line coming off it, but that is honestly plenty of room and can be increased if you tweak the line a little.

























Ok so in summary, I feel pretty good with saying Holley's headers will work with 1" setbacks if you are using the solid mounts for sure. If you are using rubber I believe you will also be fine. I chopped off the ears on my trans prior to this install (previous attempt at fbody header repurposing). If you some how still have the AC box with these mounts (engine will hit suitcase fosho...then I think these headers will not interfere.

I'm honestly a little depressed that I am pulling the engine to install the rest of the holley kit since this setup fits so damn well. Hopefully Reassembly will go just as well!!!