Quote:
Originally Posted by MCB Matt
You might as well go 3" if the cross member will allow. I have heard about quite a few guys not getting along with that cross member! What did you have to do to it to make it work?
Great to see the car finally close to done!!
Matt
|
Cut a lot out of it. First the crossmember was touching the floor. Only bairly. I had to cut the top down. In order to get to the 3 degree angle i had to cut underneath it exhaust cut outs. The headers were in more than the arches so i had to remove even more metal and offset the crossmember to the right side of the engine. Total PITA.
I still need to learn it up and paint it.
