Quote:
Originally Posted by conester2013
Another issue I had, that I'm not sure others had, was when I went to install the front coil overs on the lower strong arm, the aluminum spacers they give you that go on each side of the coil over were too big to fit in between the strong arm center bars and I had to sand one spacer down until I could get it to fit. I took the other side to a machine shop and had them shave a couple thou off so they went in easier. Not sure why that was an issue, but I was a little disappointed I had to even do that.
|
I had to sand some of my spacers as well to get them to fit.