Quote:
Originally Posted by bergers59
I'm trying to make a decision whether I want to go big bar/soft spring, or soft bar/stiff spring. From the research I've done, I've mostly found articles pertaining to late model asphalt cars rather than autocross. From what I can understand, soft springs are good for rougher surfaces(parking lots for autocross?) and making the tires work. I intend to run c prepared(slicks) and maybe a few 200tw events. Car will be 80% at track, so ride quality is of little concern. It seems as though BBSS requires different geometry(less camber change) to accommodate increased dive, and more testing/tuning to setup, is this true? I understand its a subjective question, but which setup is best for my application?
|
I've been watching this thread some, and I decided to throw in a couple of cents worth. OP, you are right in that the BBSS (high travel/low roll) works because of the geometry changes the high travel produces - for example, caster gain that results in correct camber movement for BOTH tires, not just the outside tire when they are turned. After studying Ron's posts (and many other sources on the subject) and talking with Ron personally, I made the move and cut several thousand dollars of C6 suspension out of my unfinished project track car and started over. To make a long story short, there isn't a piece of the car forward of the firewall that wasn't cut, moved, or massaged to accommodate big tires traveling 4 inches in compression (with proper geometry) and still being able to turn without hitting something- frame rails, front cross-member, sway bar mounts, inner fender wells. etc. I guess I'm saying that your decision on whether or not to go BBSS should involve careful analysis and preliminary design work to see the extent of the changes required and to see if all of the effort and expense is worth it to you. It is more than changing the springs and sway bar on a production-based vehicle. Good luck with your project.
Pappy