Here are the pics. Wayne sent it to me, it is a PDF file, I pulled pics off of it to post.
www.kwikperf.com 417 955-1467
[email protected]
Kwik Performance Low Mount AC Bracket for Sanden SD7B10--7176 “mini” compressor
Prototype V.4.2 mounted on truck engine with Corvette balancer (same belt spacing as LSA)
Two components bolt to original AC bracket holes.
Compressor driven by 4-rib belt running off the original AC balancer grooves.
Spring tensioner provides belt tension.
Bottom of tensioner well above bottom of balancer. Overall width from center of crank to outside edge of compressor approx. 12”.
Typical aftermarket engine mount with slight set-back from “stock” location with early SBC isolator. Front edge of engine mount still clears back of compressor.
Above: Comparison of stock LSA compressor with Sanden SD7—7176.