[lsuguy]

And last but not least pictures of various stages as I installed the front subframe, rear suspension and wheels. Also ran into a couple of snags here. For one you will note the hubs on the front wheels protrude past face of the wheel. Not exactly the look I was going for but I have come up with a plan to correct and parts are ordered/on the way. Two, the tie rod is interfering with the wheels but the same solution to problem one also corrects problem two. What the hell, it's just money right?

The only issue with the solution to problem #1 and #2 is that my brakes that I currently have won't work. Anyone need a set of mocked up Track 4 Baer brakes????

IMG_0084

IMG_0067

IMG_0083

IMG_0082

IMG_0068

IMG_0053

IMG_0052

IMG_0051

IMG_0050

Thats it for this update..next round of updates will likely be a motor. Still deciding which route but believe I am set on builiding a 416 Stroker LS3 using a low lash roller setup. If you aren't familiar with a LLR setup just google and look at the results guys are getting from stock cube LS3 motors.