[bsharpe]

I spent another day trying to square up the rear axle and the front subframe. The rear is in a good spot except the driver side qtr panel is 5/8" wider.

Sadly, I cant get the front subframe where it needs to be. The wheelbase is shorter on the driver side and my cross measurements from corner to corner are longer from front passenger to rear driver side. This tells me I need to move the passenger side back but it seems like I am maxed out.

Im also having trouble believing the measurements since the subframe looks to be angled to much already.

Something is wrong and I am having a lot of trouble pin pointing it. The subframe has its issues but i don't think its that far off. The body has been banged up but it is solid and seems straight.

It is difficult to get good measurements on the car when the tolerances were so bad originally. I have been going off the rear frame, the pinch weld(are they supposed to be parallel?) and the body.