Quote:
Originally Posted by jlwdvm
If your wheel base is the same on each side, wouldn't the rear end have to be square with the front subframe (since the wheels are attached to it)? The 4 corners made up of the tire patches would be square...right? I have the sub centered side-to-side according the the pinch welds. Currently I have the wheel base within an 1/8" when comparing drivers side to passenger. I am using wheel studs on the rear with the car at ride height and a level placed on 2 studs and then measuring to a stud on the front rotor after doing the same and also making sure the rotor is the same distance from the frame so toe isn't a factor.
|
Sounds like it's in pretty good shape then!! Try to get the wheelbase a little closer if at all possible. If not - it probably didn't leave the factory anywhere near an 1/8th.
Drop a point of measure off all four corners and measure on the diagonal... that's how you check for square. If that checks out - you're golden.