A little progress to show .... school is in session so I have allocated time to work on the Camaro. Welded the plates in the seat support back, and started fitting the outer AMD skin to the OEM window channel on the diver's side rear window. Left them screwed together and cut thru both pieces of metal at the same time ... came out ok!
I had previously welded on angle across the window opening for a reference ... the passenger side is a little wider and I have to put tension on the drivers side to get that gap ... so I'm just gonna put her back to where GM had it!
Take a look ...
Gonna spray some Eastwood internal frame coating on the underside!
Held in place ... gotta close the gaps a little!
That's the pass side gap at the same spot against the driver's side gap... wider fer sure!
Think I'll leave her the way GM had it .... crappy tolerances!
That's all for now ... gotta get some homework done now!
Thanks for looking ...