Quote:
Originally Posted by snappytravis
So your fan setup is like this one? Then I plugs into controller. Then on the input side of pwm controller you have power, ground and trigger wire from your holley hp output extension harness?
|
Yes, that is my fan. The shroud even has a place for the controller to sit in.
There are a lot of details in my build thread:
http://ls1tech.com/forums/conversion...es-videos.html
The controller has 5 wires. Positive and negative that go to the fan, the positive and negative from the vehicle power, and the PWM- signal wire.
For power going into the controller I have the negative coming directly from the battery and the positive also from the battery but going through a 40 amp circuit breaker connected through the 3 cavity metripack 480 connector.
The PWM- signal wire goes from the 558-400 sub harness that connects to the Holley main harness. That wire also goes into the 3 cavity metripack 480 connector. All power wires are 10 gauge, while the signal wire is only 20 gauge. The 558-400 harness comes with 20 feet for each lead so there is plenty to run just about anywhere. Few more pics...
Andrew