Quote:
Originally Posted by waynieZ
We got the top part of the latch in place and are lining the bottom up to find the final location. We'll set and mount it.
Here's the starting location.
I tried to clearance the top holes on the radiator side to move the plate to the drivers side but it threw off the front piece that bolts to the header panel. Thank god for finish washers. |
Wayne, weld a flat piece of 1/2 inch wide 1/8 inch strap to the bottom for your hood support. Cut the horizontal tab off the center support and drill a hole throught the top of the support then through the tab welded to the bottom of your lower hood bracket you built. Looking good. Progress,, that 's all we need is a little progress..