That video talks about using pins in the front alignment holes which is good, but it says nothing about using the rear alignment reference holes which are located just forward of the front leaf spring mounts. These rear reference holes are intended be used to cross measure the sub frame for square much more precisely than the pinch weld. Using the rear reference points in conjunction with the front alignment holes, I was able to square my sub to within 1/64" front to rear and side to side.
__________________
Steve Hayes
"Dust Off"
68 Camaro
Speed has never killed anyone. Suddenly becoming stationary, that's what gets you! "Jeremy Clarkson"
Last edited by TheJDMan; 10-22-2015 at 07:44 PM.
|