Collected info>>>>>
- Hook the vss output wire ( brown ) from the bulkhead to the speedometer signal wire
- Hook the tach ( white ) from the bulkhead to the gauge tach signal wire
- Hook the Oil pressure ( Tan/white ) from the bulkhead to the gauges signal wire
- For the water temperature, there is a port located on the right side (passenger side) of the engine, in the cylinder head, past the last exhaust port (closest to the firewall / flywheel). There is a plug threaded in this location, that can be removed. This threaded in plug will either require an 8mm Allen Wrench, or a T52 Torx bit. There will be no noticeable difference in temperature reading when using the shorter sender. The 2277 adapter requires a 3/4" wrench, and the 2259 sender requires a 12mm wrench. Be careful to only tighten the adapter into the head until the crush washer is flattened. Do not over tighten. This is for the short sweep water temp guage
- for the voltmeter just hook up the ignition wire from the gauge harness to the gauge
- Samoco unit should be used for the reverse lockout solenoid. You could run it off of the brake pedal but some people have stated some issues. Link to the samoco unit is
http://www.wirebarn.com/T56--TR6060-...ule_p_470.html
- The for fuel gauge run ......