[kwhizz]

Got a new Air Filter assy that has the provision for the newer style Mass Air Flow Sensor built into it.....Didn't think the Filter would fit into the opening in the fender......This assy was provided by Edelbrock in the Kit.....But...I didn't think it would fit and I modified the old set-up to fit....That's when I found out about the plug being different and the MAF Sensor issue........I guess in the end the way Edelbrock had it set up is actually the right way to do it.......Parts on order......and the Huge air filter fits perfectly in the fender opening.......Again......."I are smart".......LOL........Anyhow.....as you can see it fits perfectly.....I also went to the parts store and pieced together Radiator Hoses to make a new top hose........The shrink clamps will be here on Monday to get that finished also......I also roughly mounted the Heat Exchanger and got the pump and all the hoses hooked up.......Just need to make some upper and lower mounting brackets for the final positioning...........I also hooked up a Vacuum pump to check and see if the A/C system would hold a Vacuum..........as you can see in the picture after sitting for a hour .......no problem.......getting closer