This adapter will thread into the drier and _should_ work with the GM sensor noted above. I am waiting for my sensors to get here and confirm.
18103-VUG
All the driers have two ports on them now so if you can package it with the sensor and the binary switch you are done.
If not, there are inline fittings available.
347561-VUR #6 ez clip
34829-VUG #6 beadlock
Parsons noted earlier that GM puts the sensor in the #8 between the compressor and the condenser, that would allow the ecm to see the highest pressure in the system and is likely the best spot for it. When I get to charging the AC, I'll keep an eye on how the fan cycles in relation to pressure and adjust the table as needed. I don't expect a need to do that though.
__________________
Donny
Support your local hot rod shop!
|