[64mali]

So it's funny how I underestimate time and materials sometimes, lol. I started to lay down the Dynamat Extreme and figured I would start from the rear. I went to clean the old glue off the package tray and ended up stripping it to metal. Once I was in it that far I figured there was no point in leaving the huge square holes where the roll bar goes through so I made filler panels. Next a little epoxy prime and I can finally start my Dynamat project.

So I start laying the Dynamat and was waiting for my Dynaliner and the cardboard rear seat divider to show up. I ordered the divider and package tray minus the old jute pad because I figured the Dynaliner would be way cooler. Then it gets here. So for whatever reason I didn't pay much attention to the amount of Dynaliner that comes in a roll and figured I would probably get the back half done. LOL, I certainly underestimated that one. So I have a very nice divider board that just quadrupled in value. HaHa. This sound deadening adventure isn't going to be cheap. I'm happy with the outcome so far though.

Sorry not a very exciting update but I am looking forward to getting my interior back in.