[cjsgarage]

The original rear end needed to come out to make room for a V8 axle so I took off the drums and disconnected the parking brake cables. I also undid the u-bolts that were holding it onto the springs.




So I'm left with the leafs and shocks sitting back here. You can see the '68 'Stang in the next bay over through the wheel well openings.




After I set the weld in plates on the springs, I hoisted the shaved '94 rear end up there.





And, lastly.. the driveshaft is going to need to be lengthened just a little bit. And after I raise the transmission mount a tiny bit, the driveshaft won't scrape the tunnel bottom at full droop.