continued from above
We all liked what he had in mind, and were eager to get started. We had to finish another project first, but that was soon done and we began on this '69 Camaro in May of 2015.
The car rolled into our shop as a semi-built rolling chassis. The amount of tear down shown below may seem excessive, but there wasn't a single piece of the old car cut out that wasn't done for a good reason. I'm not going to get mired in knocking down the work done to this car before it got to our shop - I'm just showing what we did - but I might mention our reasoning here or there.
Beginning of Tear Down
We had agreed upon a course of action with our client and he had signed off on all of the changes we had in mind. We told the owner that to get the car back to a rolling chassis that was safe/competitive/reliable would likely take a certain number of hours of tear down and rework, which was approved. When Ryan was freed up from another cage build, he was ready to tear into the Camaro and he jumped right into action. Tear down is chronicled in the short 24 second time lapse video below, taken on 5/11/15.
Time Lapse Video of Day 1 of Tear Down
The engine and trans were removed and the existing roll cage was cut out. Its painful to remove parts and work that has been completed, but a necessary step in order to move forward. We really "ripped the Baind-Aid off" on day 1, heh.
The front subframe was removed, with an eye towards possibly re-using this section. It was a name brand 1st gen F-body subframe designed for C6 Corvette control arms, hubs and uprights, then modified heavily for this car. We see them on lots of Pro Touring builds and assumed it probably had decent geometry (which we would later check).
This car had a custom floor and frame built to replace the OEM floor and unibody structure, but for various reasons it all had to go. Ryan used plasma cutter, saws-all, and other tools to get these pieces out over the course of a few days.
Once he started on this Camaro we couldn't get him to stop - he was having too much fun. Of course we cannot work on one car non-stop for months, and Ryan split his time on other customer work here and there, but a lot of time was logged on the '69 from May through July.
The rear frame rails and trunk floor were also removed, all of which was off-the-shelf kits adapted to this car previously. The deconstruction totaled only 16 billable hours for the steps shown above. The 2x4" rear frame rails that were previously installed on the car were only 1/4" thick (see below) in long horizontal sections near the inboard sections of the rear tires. With 345mm Hoosiers and their cornering loads transferred to the frame in these narrowed sections, we had concerns, so all of that came out.
The solid rear axle housing was a big beefy custom Ford 9" unit with lots of extras, and we would end up re-using that for the build. It had no "guts" (bearings, seals, axles, gears, or diff) so we would be ordering all of that later. The front and rear shocks were only "mock-up" shocks, made for eye-to-eye mounts and with a pin to change the length during chassis setup. Handy things to have when you are building a car from scratch. After a few days of loud cutting and flying sparks later it was ready to begin reconstruction - all of this happened very fast.
continued below