Okay --- are you using a brand new ignition switch?
Do this for me ---
Take your volt ohm meter -- get to continuity mode -- red or black lead on where you THINK the purple starter wire should be - do the other red or black lead to ground - any ground.
Take the power from the battery OFF the ignition - just disconnect it.
What we're searching for is which terminal makes a tone on the volt ohm meter when you turn the key all the way to START. AND the tone goes away when you release the key to "run". NOTE WHICH TERMINAL ON THE SWITCH DOES THIS.
All the other terminals should make continuity (a tone) when in RUN or ACCESSORY.... BUT NOT when in "START".
See if that helps you figure out if it's the ignition switch or your wiring.
|