Quote:
Originally Posted by Vega$69
In rebuilding the column the switch is installed. The switch does not have any wires. The wires come via the plugs on your AAW harness. Simple plug and play. The purples runs from switch to neutral safety and to starter. It is only energized when key/switch in in start position.
Check the wiring at the starter. In addition to what Greg said you can use the meter set to VDC and with purple disconnected from starter. Red to purple wire black to ground. key on should be zero volts. Key in start position 12v
|
Right, but I removed all but the battery wire from the plug and reinstalled it into the switch. I moved the key into the accessory, ignition, and run positions and had no power to any of the ignition tabs on the switch. Doesn't this localize the problem to the switch? Power isn't getting from the battery side to the ignition side of the switch?